Help with dforce morph not saving

Comments

• DrunkMonkeyProductions Posts: 1,317

  August 13

  How did you create the morph?
  If you're using a modeler, like z-brush, you need to be sure not to add or remove geometry.

  You'll probably need to start over and make sure to not add/remove geometry.

   
• felis Posts: 6,514

  August 13

  And make sure you set resolution to Base before exporting from Daz Studio.
• crosswind Posts: 10,276

  August 14 edited August 14

  This hair is a strand-based hair.... you exported and manipulated the polylines in other software ?

   You have to activate Geometry Editor before export / impotr the SBH - OBJ, otherwise you'll get the geometry mismatch error.

  Post edited by crosswind on August 14
• DMinds Posts: 52

  September 4

  Sorry, just saw these messages I'm using the dforce2morpht  https://www.daz3d.com/dforce2morph?srsltid=AfmBOorRVSaUZ4skshAP7HojmMH8C0non-nfw-KwGyMvDKykuRaaQ1WR

   

  when i try to save it gives me that error 
• crosswind Posts: 10,276

  September 4 edited September 4

  I'm not sure if dForce2Morph can correctly work with strand-based hair ~ You can ask the PA who made the product: https://www.daz3d.com/forums/profile/2970716/RiverSoftArt

  Post edited by crosswind on September 4