Geometry Shell Visibility

Melissa Conway

Is there a quick way to turn all of the surfaces off? I just want one to be visible and it's a pain to click on each one individually. tx

scorpio

Select all the surfaces turn the opacity to 0 in the surfaces tab then turn the one you want to 100 or whatever you want it at.

Havos

Another way which switches the surfaces off is to click on the Parameters pane with the Geo shell selected. Go to Shell->Visibility->Surfaces

Now switch to Edit Mode (Right click on one of the surfaces), now select all except the one you want to remain visible, right click again. Set->Value(s).

A pop up will appear, click on "ON" and it will change to "OFF"

Now all except one should be OFF. Right click again to leave Edit Mode.

Linwelly

scorpio said:

Select all the surfaces turn the opacity to 0 in the surfaces tab then turn the one you want to 100 or whatever you want it at.

This will give you gloss artifacts and similar stuff, it's better to turn off the shell visibility in the parameters as Havos explained

Melissa Conway

Thanks!