Loading...
> >

My characters look like aliens

Haruki790Haruki790 Posts: 64
in Technical Help (nuts n bolts)

Hi,

So my new characters I've bought in the past week all load with shrunken heads and large bodies, older ones load fine,

is this a measure metrics thing 'cause I'm still using 4.24?

Thanks

Comments

  • Richard HaseltineRichard Haseltine Posts: 111,095

    It is very unlikely to be due to the DS version used. Is this affecting the base figure? How were the ones that still look right saved?

  • Haruki790Haruki790 Posts: 64

    It seems to be off and on, old figures sometimes load good, other times not, only affects characters - everything else looks normal.

    Genesis 9 base loads as a female, 8 male loads good.

  • GhostofMacbethGhostofMacbeth Posts: 1,772

    You have a figure that is auto applying, I think. Go to the parameters and see what is active 

  • Haruki790Haruki790 Posts: 64

    Yes, that did the trick, thank you so much, how did this happen and what can I do to prevent it?

  • Richard HaseltineRichard Haseltine Posts: 111,095

    Most likely something you have added recently was saved with a non-zero value for one or more morphs. If it was a character morph that needed zeroing that probably tells you the culprit.

  • Haruki790Haruki790 Posts: 64

    That is the strange part, the offending character was one I had just bought and downloaded but done nothing else with, so how it got into my Parametrs tab  is a mystery.

  • Richard HaseltineRichard Haseltine Posts: 111,095

    If a morph is saved with a non-zero value it will auto-apply, you don't need to do anything. Sometimes properties need to start with a non-zero value (e.g. if they are going to have something else subtracted from them to make an inverter) but general character shapes should not be saved like that. It is most likely a product bug and should be reported to Daz (for content purchased here) or the artist.

  • Haruki790Haruki790 Posts: 64

    Ok thank you, I'll do that.

Sign In or Register to comment.