Loading...
> >

Can't get out of wireframe after fluid modifier

jason-2455927jason-2455927 Posts: 51
in Blender Discussion

So if I add a fluid modifier to the mesh it switched over to showing my mesh in wire form. No matter what I do after that I can't seem to switch back into solid mode. What is going on with that?

Comments

  • TheKDTheKD Posts: 2,711

    Go to object properties tab(looks like a orange square on my install) and under viewport display change it from wire to however you want it to display. One of my biggest annoyances about blender, controls are all over the place, and sometimes not easy to find what you want to change lol

  • SDevSDev Posts: 158
    edited June 2021

    jason-2455927 said:

    So if I add a fluid modifier to the mesh it switched over to showing my mesh in wire form. No matter what I do after that I can't seem to switch back into solid mode. What is going on with that?

     

    Some pics concerning wireframe options :) You can also set the opacity to a lower value to reduce the visibility of the wireframes. 

    Wireframe.jpg
    469 x 461 - 48K
    Wireframe quick menu.jpg
    998 x 567 - 149K
    Post edited by SDev on
Sign In or Register to comment.