Anyone one else having issues with the new Road Trip Hippy Van?

Comments

• Taoz Posts: 10,341

  September 2017 edited September 2017

  Have another version I bought a few years ago in another store, never used it so decided to check it out and compare. It showed up to be just an obj, plain mesh with no textures except a few with logos for the roof and spare tire, no rigging, and no interior at all. Cost $12. Here they are together, I've used mec4d's shaders for the old one.

   

  

   

   

  

  

  vw_both_01.jpg

  1780 x 1070 - 910K

  Post edited by Taoz on September 2017
• Boorsman Posts: 283

  September 2020

  Does anybody know what the backseats are suppoesed to be sitting on?  When I turn the bedding off, and turn on the backseats, the rear backseats are on the raised part of the van, while the front backseats are hovering in the air.  M I missing something?

   
• kyoto kid Posts: 42,368

  September 2020 edited September 2020

  Mattymanx said:

  th3Digit said:

  in regards to pivots

   but DAZ studio one needs to make it a figure and fiddle with those tiny red and green hip bone arrows is a right pain.

  Why doesn't DAZ studio have an easy way to set pivots on props?

   

  Use the Joint Editor Tool and the Tool Tab to change pivot points.  Its the exact same tool PAs use when rigging the models.

  ...I had to do that with the luggage hold doors on the Greyhound Scenicruiser Bus from Rendo as well as they would pivot at the centre not the top. A small inconvenience considering the only other models of it I've seen are on the pro sites and like patwojtko mentions, cost 100s..

  Post edited by kyoto kid on September 2020
• WendyLuvsCatz Posts: 41,415

  September 2020 edited September 2020

  this thread was necroraised from tne dead

  I apparently bought it since too but not even used it yet 

  (and caught flack from a user for criticism when I hadn't even bought it yet  was asking about the rigging)

  Post edited by WendyLuvsCatz on September 2020