The Clinic question

Comments

• frankrblow Posts: 2,052

  November 2018

  Unfortunately, the walls, floor and ceiling are all one piece (ie: a box). You need to edit the mesh to make part of it invisible. The door is not part of the "box" but it does not have an open/close dial, and you need to fiddle a little with parameters to make it work.
• miladyderyni_173d399f47 Posts: 2,544

  November 2018

  Thanks, I was afraid of that. I may get it just for the props. Still trying to decide.between it and https://www.daz3d.com/futuristic-laboratory
• Richard Haseltine Posts: 108,795

  November 2018

  dragonfly_2004 said:

  Unfortunately, the walls, floor and ceiling are all one piece (ie: a box). You need to edit the mesh to make part of it invisible. The door is not part of the "box" but it does not have an open/close dial, and you need to fiddle a little with parameters to make it work.

  For Iray you can also use a Section Plane (Create menu)
• FSMCDesigns Posts: 12,846

  November 2018

  Richard Haseltine said:

  dragonfly_2004 said:

  Unfortunately, the walls, floor and ceiling are all one piece (ie: a box). You need to edit the mesh to make part of it invisible. The door is not part of the "box" but it does not have an open/close dial, and you need to fiddle a little with parameters to make it work.

  For Iray you can also use a Section Plane (Create menu)

  or the geometry editor. Just select the glass in the dividing wall, create a new material  and then turn down the opacity. Same for the molding/frame around it. took all of 2 minutes

  

  

  clinic.jpg

  1479 x 879 - 2M
• miladyderyni_173d399f47 Posts: 2,544

  November 2018

  I think I will give it a try. Thanks all! Doing anything with geometry is an old "fear" of mone, although I love playing around with shaders.