Need a Winding Staircase in Medieval Building

Comments

• Chohole Posts: 33,604

  March 2016

  http://www.daz3d.com/castle-turret
• Paula Sanders Posts: 321

  March 2016

  Thanks, Chohole. I added it to my wish list until it comes on sale.
• sriesch Posts: 4,243

  March 2016

  I'm not sure if this is perfectly round, but if so, perhaps it could be kit-bashed to run around the inside of a tower that is resized slightly to fit? http://www.daz3d.com/serenity-arches-pack ; and retextured to match the tower walls?

   

  This next one isn't medeival so it probably won't work, but maybe in certain circumstances you could do something with it: the steps would be metal instaed of stone, but maybe you could do something with http://www.daz3d.com/parkside-point-interior depending on exactly what you are looking for. 
• vwrangler Posts: 5,007

  March 2016 edited March 2016

  One thing to note about Castle Turret is that it's MASSIVE. Somehow, not too terribly hard on an average system, but it fills the entire grid system in the workspace and extends some distance below the workspace floor, and a bit above as well. When I used it, I was working with the exterior, not the interior, so I wound up deleting a lot of stuff to pull down the load on the system. Still definitely worth the purchase.

  A question: how much of the stairway and surrounding building will you be showing at one time? Shifting Images, one of the PAs here, has a freebie, used in a medieval dress product promo, that has part of the stairs and part of the wall: http://www.sharecg.com/v/72653/browse/21/DAZ-Studio/Shifting-Images-Free-Stuff-Simple-Stairway

  Post edited by vwrangler on March 2016
• Paula Sanders Posts: 321

  March 2016

  Thanks to all for your ideas. I did find two models I can use, One I know will work from another vendor and one I purchased from DAZ but haven't tried yet. I think I own the stairs from sharecg.