About "Duplicate formulas found in file" issue
mazinkaiserzero
Posts: 214
Hi, I know about this issue in general already but I was wondering, if loading a Genesis 8.1 figure gives you that error, should it happen as well when loading a Genesis 8 figure? (or viceversa)
It's my understanding that Genesis 8 and Genesis 8.1 share morphs so I would be inclined to believe that it's not possible to get a duplicate error only when loading one of them and the other one would be fine... right?
Post edited by mazinkaiserzero on
Daz 3D is part of 
Connect
DAZ Productions, Inc.
7533 S Center View Ct #4664
West Jordan, UT 84084
Licensing Agreement | Terms of Service | Privacy Policy | EULA
© 2025 Daz Productions Inc. All Rights Reserved.
Comments
G8.1 loads G8 morphs but G8 won't see morphs created specifically for G8.1.
So if the morph causing the problem is a specific G8.1 morph you would not get an error when loading G8.
It is usually a conflict between two morphs, so if only one of them is for Genesis 8.1 then Genesis 8 will load without the warning.