Fast Extrude

KevinHKevinH Posts: 935
edited December 1969 in Hexagon Discussion

I'm sure this is simple,....but I can't figure it out. What key do you have to hit or what do you have to do to drop the first extrude so you can do the next extrude. I read the manual, but it seems to over look that detail or I am overlooking it.

Thanks.

Comments

  • KevinHKevinH Posts: 935
    edited December 1969

    Never mind. I figured it out. You don't have to hit anything. You just stop...let up on the mouse... and then start again. I guess I was trying to use it like the sweep tool.

  • Wee Dangerous JohnWee Dangerous John Posts: 1,278
    edited December 1969

    Glad you figured it out. I would like to recommend watching these tutorials, they are 26 shorts by Danny, well worth a look -

    https://www.youtube.com/watch?v=zu-xZNYYv20

    They used to be on CG-Dreamss site but for some reason the link is broken.

  • KevinHKevinH Posts: 935
    edited December 1969

    Thanks for the link to the tutorials. I found them very helpful!

Sign In or Register to comment.