Loading...
> >

How to keep the autofit working on geometry

lululee1lululee1 Posts: 343
in The Commons

Hi,

  I have some geometry I created.

It was created for G8

I Autofit it to Genesis 8

I put all of the morphs in

Saved it as a support asset -figure/prop

Then saved it as a wearable preset.

When I re-load it as a wearable preset it asks me again who it was made for.

How do I get to keep it's autofit memory?

Any advice is appreciated.

Cheerio

lululee

 

 

Comments

  • Richard HaseltineRichard Haseltine Posts: 109,065

    AutoFit is for already rigged content, so you wouldn't have used AutoFit on the base OBJ - that would presumably have been the Transfer Utility. Is your content management service running correctly, as far as you can tell? Are you sure you have Genesis 8 seelcted in the scene not, for example, the lashes (I'm not sure if that would matter but it might)?

  • lululee1lululee1 Posts: 343

    Thanks so much Richard.

    I'll look into this.

    Cheerio

    lululee

Sign In or Register to comment.