Loading...
> >

Does Loft Bath dForce Robe for Genesis 8 Female(s) open?

IllidanstormIllidanstorm Posts: 655
in The Commons

Hello,

I have a question for this item https://www.daz3d.com/fg-loft-bath-dforce-robe-for-genesis-8-female

it is possible to open it up with dforce without too much trouble? I'm not so expirenced with dforce.

Comments

  • maikdeckermaikdecker Posts: 3,037

    It's dForce and it has a belt. And there is nothing said about any morphs except a few fitting ones in the promo.

    So I'd hazard the guess that it won't open.

  • IllidanstormIllidanstorm Posts: 655
    Ok, I think I will buy this one then when it's on sale because it is useless to me. https://www.daz3d.com/i13-hq-bathrobe-for-the-genesis-3-female-s
  • IllidanstormIllidanstorm Posts: 655
    edited March 2018
    Double post
    Post edited by Illidanstorm on
  • ALLIEKATBLUEALLIEKATBLUE Posts: 2,983
    edited March 2018
    There is a picture of it open with a morph called open. Oh sorry this comment applies to the second robe you linked.
    Post edited by ALLIEKATBLUE on
  • Richard HaseltineRichard Haseltine Posts: 109,366

    If the belt has its own surface, or if you give it one via the Geoemtry Editor, you could set Visible in Simulation off - unless the robe mesh is actually joined below that it would then fall open, though you'd have to do semthing with the belt (such as hide it, perhaps replacing it with a dForced thin plane stretched long).

Sign In or Register to comment.