What's going on with G9 surfaces and Subsurface?
TOPcat831
Posts: 8
The 1st image is a G9F skin texture created using FaceGen and the 2nd image is after loading the G9 Feminine Skin Mat to obtain the extra surface nodes. All I did was replace the skin textures from before. Settings for "SSS Enable" are the same for the head, body, legs & arms. I can't figure out why the texture for the arms aren't displaying properly in Iray when the rest of the textures are working just fine.
Daz 3D is part of 
Connect
DAZ Productions, Inc.
7533 S Center View Ct #4664
West Jordan, UT 84084
Licensing Agreement | Terms of Service | Privacy Policy | EULA
© 2026 Daz Productions Inc. All Rights Reserved.
Comments
In genral this would be a question about a piece of content, not Daz Studio, and so should be in Technical Help. However, I suspect there is a generic DS answer - one or more of the textures on the arm has a different gamma setting from the equivalent maps on the rest of the figure. You can see the gamma value by clicking the nano-thumbnail next to a proeprty with a map in Surfaces pane>Editor tab and selecting Image Editor (not Layered Image Editor).