Loading...
> >

cannot take the glossiness off of g8 with n-g-s-anagenessis-2 applied

VicSVicS Posts: 1,273
edited December 2022 in Technical Help (nuts n bolts)

cannot take the glossiness off of g8 with n-g-s-anagenessis-2 applied

i tried every slider in surfaces , glossiness, top coat, glossy layered wieght

this image is with a spot lite, without a spotlite it is a little gloosy in some places but nowhere near as bad

will be good to know how to cut it down for both scenarios

thanks

Post edited by Richard Haseltine on

Comments

  • Richard HaseltineRichard Haseltine Posts: 108,072

    Moved to Techncial Help - please post questions about products here, not in Daz Studio Discussion.

  • VicSVicS Posts: 1,273

    ok

  • robertswwwrobertswww Posts: 799

    @VicS To remove the glossiness, try lowering or turn to 0 (zero) your Dual Lobe Specular Weight, your Lobe Roughness controls, and/or your Base Bump.
    NOTE: If you don't see these controls, set your Base Mixing to PBR Metallicity/Roughness.

  • VicSVicS Posts: 1,273
    edited December 2022

    thanks Robert , will try later in day, tried it works fine, thanks again

    Post edited by VicS on
Sign In or Register to comment.