G8F Skin on G3F, possible?
3dOutlaw
Posts: 2,481
in The Commons
I was wondering if there is a process or product to do that? Thanks!
Daz 3D is part of 
Connect
DAZ Productions, Inc.
7533 S Center View Ct #4664
West Jordan, UT 84084
Licensing Agreement | Terms of Service | Privacy Policy | EULA
© 2026 Daz Productions Inc. All Rights Reserved.
Comments
Save the material settings, load the material settings.
load both copy settings in material tab, paste onto other figure
Personall I prefer to load both and just copy across; i can do them all, or just some, or mess about transfering eyes from another figure.
I mostly just load the textures and use Agenesis 2 for G3 Female, works fine on G8 too btw (I rarely transfer from G8 to 3).
G8F skin can be used on G3F. The major issue is that most duf files to apply it are hierarchical and include the eyelashes which throws an error on G3F. If you highlight just G8F without the eyelashes and save it as a material preset it will work on G3F.
I just went into the Surfaces tab and copy/pasted the same G8F skin onto a couple of G8Ms, as well as two G3Fs, and a G3M for a scene. You need a UV swaping utility, and I've picked up more than one of them, so I can't say which one was being invoked. But the list of potential UVs for all of the figures was in the popup of the survaces tab.
I will admit that the three G3 figures all have their backs to the camera, so I am not sure if there were any issues with the eyes and eyelashes. But I just selected the Skin-Lips_Nails surface and copied that. I didn't do anything with the eyelash figure between the G8F and the G8Ms.