Loading...
> >

Vary Transparency -- Is that Possible?

inquireinquire Posts: 2,434
in Daz Studio Discussion

Is it possible to vary the transparency of characters, or parts of characters, or hair, or clothing, before doing an iRay render? I've looked in Surfaces, and I can't figure out how to do that.

Comments

  • SimonJMSimonJM Posts: 6,067

    Look for the Cutout Opacity paramter under Geometry under the Surfaces tab.  It can take a greyscale map to have varying opacity.

  • inquireinquire Posts: 2,434

    Are you saying that this will usually or always work? Or, are you saying that this will only work if there is a greyscale map in Surfaces -->Geometry -->Cutout Opacity?

  • hphoenixhphoenix Posts: 1,335
    edited May 2018
    inquire said:

    Are you saying that this will usually or always work? Or, are you saying that this will only work if there is a greyscale map in Surfaces -->Geometry -->Cutout Opacity?

    Cutout Opacity (in IRAY, it's a different surface property in 3Delight surfaces) applies to the entire surface.  IF a map is present, it maps transparency across the surface (so you could make only part of the surface transparent).  The value and/or map determine HOW transparent it is.

     

    Post edited by hphoenix on
  • inquireinquire Posts: 2,434

    YES! OK, I found it, and I was able to get two items transparent. So it worked for me in these cases. Thank you very much for your help, both of you. I'm grateful.

Sign In or Register to comment.