JCM Hook Up Question

Comments

• ChangelingChick Posts: 3,362

  April 2018

  marth.e said:

  Does anyone know if it's possible to have a JCM that depends on two or more conditions. For example, a JCM that will activate when the arm is up AND back and not only when it's up OR back. Is that possible?

  Cheers,

  Martha E.

  That is a multi-rotational JCM and it is, indeed, possible. I do not know how to do it though :D But you can put a TON of conditions on a morph. If you're searching the forums, wiki or YouTube, multirotational is what you're looking for.
• marth_e Posts: 187

  April 2018

  Thank you very much, ChangelingChick. Is good to know it's possible. I'll try to find more info. Thanks for the tip.

  Cheers,

  Martha E.
• marth_e Posts: 187

  April 2018

  I can't seem to find any info about multirotational JCM. Do you remember where did you see it? Thanks again.

   
• ChangelingChick Posts: 3,362

  April 2018

  marth.e said:

  I can't seem to find any info about multirotational JCM. Do you remember where did you see it? Thanks again.

   

   

  I don't I'm afraid :/ Do you use Property Heirarchy or ERC freezes?
• marth_e Posts: 187

  April 2018

  I'm using the Property Heirarchy to hook up the JCM.
• ChangelingChick Posts: 3,362

  April 2018

  You can drag more than one thing onto a control as I recall, and there are 2 stages for controllers I think (1 to add, 1 to multiply maybe?). I would experiment a bit with those, just remember to have the morphs saved before you hook in the JCMs. Sorry I can't help more :(
• marth_e Posts: 187

  April 2018

  Thank you very much ChagelingChick. Yo have been very helpful already. I really appreciate it.