ISO side stitched pants for G3F

Comments

• Illidanstorm Posts: 655

  March 2018

  Maybe this?

  https://www.renderosity.com/mod/bcs/crux-ii---rebel-rock-pants/119510/
• ColemanRugh Posts: 511

  March 2018

  Thanks Illidanstorm! Those are exceelent. I was looking for leatherwork criss cross down the seam - but thank you!  :)
• 3WC Posts: 1,145

  March 2018

  https://www.sharecg.com/v/69768/view/21/DAZ-Studio/Deep-Woods-Rover-for-Genesis

  These are free. I haven't tried to autofit them to G3F, but, hey...they are free!  :)
• Illidanstorm Posts: 655

  March 2018 edited March 2018

  Hmm no pants but boots https://www.daz3d.com/two-and-a-half-for-bootleggers-2

  Those are the only items I know that have that. Maybe it works if you put country shorts on her.

  Post edited by Illidanstorm on March 2018
• ColemanRugh Posts: 511

  March 2018 edited March 2018

  wwes said:

  https://www.sharecg.com/v/69768/view/21/DAZ-Studio/Deep-Woods-Rover-for-Genesis

  These are free. I haven't tried to autofit them to G3F, but, hey...they are free!  :)

  Very cool! Thanks a lot for the tip!

  Post edited by ColemanRugh on March 2018
• ColemanRugh Posts: 511

  March 2018

  Illidanstorm said:

  Hmm no pants but boots https://www.daz3d.com/two-and-a-half-for-bootleggers-2

  Those are the only items I know that have that. Maybe it works if you put country shorts on her.

  Thanks a lot! Yeah, there's several boots with the side stitches. Good call. Thanks!
• scorpio Posts: 8,533

  March 2018

  ColemanRugh said:

  Illidanstorm said:

  Hmm no pants but boots https://www.daz3d.com/two-and-a-half-for-bootleggers-2

  Those are the only items I know that have that. Maybe it works if you put country shorts on her.

  Thanks a lot! Yeah, there's several boots with the side stitches. Good call. Thanks!

  There's

  https://www.daz3d.com/daemon-outfit-for-genesis-3-male-s

  for males I know but autofit should work
• ColemanRugh Posts: 511

  March 2018

  Oh! Excellent find! I'll try that out. Thanks so much!
• Leana Posts: 12,901

  March 2018

  This is for V4 but could work with autofit: https://www.daz3d.com/edens-flame