Loading...
> >

save/load hierarchical pose preset without changes

srieschsriesch Posts: 4,243
in The Commons

Apparently I've forgotten how to save and then load a hierarchical pose preset without changes.  What obvious thing am I missing?  Top is posed to put a curve in the belt and then saved as a hierarchical pose preset. bottom is what I get when I apply the saved pose to a perfectly flat belt.

Comments

  • Richard HaseltineRichard Haseltine Posts: 107,968

    If it is using some kind of easy pose controls are they marked as Modifier/Pose if you look in the parameter Settings dialogue (gear icon on the slider)?

  • srieschsriesch Posts: 4,243
    edited January 2017

    It is the easypose tube, with a single shell and it's instances parented to each node.

    A randomly selected node does show Modifer/Pose in the parameters settings, see screenshot.  I did a bit of googling in the forums but I'm not sure exactly what this means or how I should take action based on this info.

    screenshot, modifier-pose.png
    316 x 413 - 21K
    Post edited by sriesch on
  • Richard HaseltineRichard Haseltine Posts: 107,968
    edited January 2017

    Thje question was on the missing settings, presumably the easy-pose sliders (if you actually used those). The other possibility is that you had only bones, not the figure itself, checked in the options dialogue.

    Post edited by Richard Haseltine on
  • srieschsriesch Posts: 4,243
    edited January 2017

    Here's a screenshot of one of the easypose settings, BendAft.  Also a screenshot of the save settings, partly expanded into a few nodes (presumably all nodes are selected).

    screenshot, BendAft parameters and save options.png
    934 x 701 - 120K
    Post edited by sriesch on
  • Richard HaseltineRichard Haseltine Posts: 107,968

    The type iss et to None - that may well be stopping the preset from including its values, I'm not sure.

Sign In or Register to comment.