Western Outlaw 2.0 for Genesis 3 questions
Knittingmommy
Posts: 8,191
in The Commons
Has anyone picked this up that can show some renders and possibly list any morphs. There are no morphs listed and yet I can see at least one possible one for the kerchief. I would love to see the back of the coat and the back of the outfit without the coat.
It would also be nice to see if there is a morph for the coat to have access to the sidearm while still wearing the coat and what it looks like. Does the vest and shirt open at all?
TIA!
Daz 3D is part of 
Connect
DAZ Productions, Inc.
7533 S Center View Ct #4664
West Jordan, UT 84084
Licensing Agreement | Terms of Service | Privacy Policy | EULA
© 2025 Daz Productions Inc. All Rights Reserved.
Comments
I don't have the product, but the file list in the ReadMe lists the morphs: http://docs.daz3d.com/doku.php/public/read_me/index/34319/file_list
Thanks for the heads up! I only have a couple of this vendor's older stuff like the previous Western Outlaw outfit. I like that outfit, but it has some issues that I don't like. While there are morphs for the coat to reveal the gun, there are no morphs for the kerchief other than a fitting morph. Sometimes, you have to unparent the holster from the leg so it doesn't follow or the gun pops out of the holster because it stays straight while the holster curves a bit, not good. I'd actually rather not have the holster autofit and just parented to the figure as that seems to work for me much better. I'm not sure if any of these issues are the same in the new outfit.
Textures, I can deal with as I don't use a lot of textures that come with outfits. Some vendors do great and some do a horrible job. Luckily, I can do my own textures when needed. Yeah, the deforming and distortion are a big part of why I only have two outfits by this vendor. Unfortunately, there aren't too many outfits like this out there. I really do like doing westerns, but it would be much easier with more quality old west outfits. :(
So, depending on what anyone adds to the thread, I'm seriously considering this even if it is flawed. I just might not get it while new if I have to do a ton of work to work with it.
I'm on the fence with this one for pretty much the same reasons. Would love to know if the shirt and vest open. Would also love to see any movement morphs for the coat. Particularly those that would allow the bottom to spread back and perhaps to the side to show movement.
I am interested in this and have the same concerns. I can probably move the duster with a deformer and even make the boots more narrow at the top to allow the pants to be over them with deformers also. On the bandana, I could always make it dynamic and see how that works if I need a special fit, hmmmm. Yeah, it definitely needs some addon textures for it. I am so jonesing for some good western garb as I have a ton of western themed renders I want to do.
No Gun? I'm scratching my head a bit - what use is a holster with no gun to put in it...?
Waistcoat and shirt don't open. Holster attached to leg again. Movement morphs for the Duster are there but they are all pretty subtle and small. Except for the Belt - where the morphs can completely distort the belt.
No gun? Are you sure there isn't a gun? That vendors original Western Outlaw for G2 had a gun with it. How could they not have a gun when they have a holster?! With those morphs, or barely there morphs, yeah, I think I'll pass! Thanks for the answer.
Yeah, no gun mentioned on the Product page either, and opened up the zip from DIM folder just in case I missed it when I was catagorising. I went off and checked the G2M version too, in case I was imagining a gun in there...
Thanks for the information everyone. :)