Loading...
> >

GenX2 - Won't Show Up in Shaping Pane Under Actor

FauvistFauvist Posts: 2,290
in The Commons

If I load Genesis (1), the GenX tab shows up under Actor in the Shaping pane.

When I load Genesis2 Female or Male, the GenX tab doesn't show up at all.

I checked the DAZ Studio plugins and it is installed and supposedly working.

What do I have to do to get it to show up for Genesis 2?

Thanks!

Comments

  • LindseyLindsey Posts: 2,011
    edited September 2016

    Genesis, Genesis 2 Female, Genesis 2 Male, Genesis 3 Female and Genesis 3 Male each has it's own folder for morphs and you must change the Output folder path to the Genesis figure's morph folder in the "Target:" setting.

     

    Post edited by Lindsey on
  • FauvistFauvist Posts: 2,290
    Lindsey said:

    Genesis, Genesis 2 Female, Genesis 2 Male, Genesis 3 Female and Genesis 3 Male each has it's own folder for morphs and you must change the Output folder path to the Genesis figure's morph folder in the "Target:" setting.

     

    Thank you for responding.  I don't understand - what's the Output folder?  Or where is it?  And where is the "Target" setting?

    Thanks.

  • LindseyLindsey Posts: 2,011

    See the attached picture of GenX2 v2.1  where I show Target = Genesis 3 Male and Output folder path = <your content lib path>/data/DAZ 3D/Genesis 3/Male/Morphs/D3D Gen X/

     

     

    GenX2 v2.1.jpg
    977 x 884 - 130K
  • FauvistFauvist Posts: 2,290
    Lindsey said:

    See the attached picture of GenX2 v2.1  where I show Target = Genesis 3 Male and Output folder path = <your content lib path>/data/DAZ 3D/Genesis 3/Male/Morphs/D3D Gen X/

     

     

    Okay, thanks very much.  I'll try it.

Sign In or Register to comment.