is there a Taper command in Hex? (yes, I found it... doh!)

wancowwancow Posts: 2,708
edited February 2013 in Hexagon Discussion

is there a way to taper an object in Hex?

What I mean is this, consistently scale the top edge of an object and all the edges down to the bottom so that you can turn a square into a triangle while leaving the bottom edge the original length.

Post edited by wancow on


  • wancowwancow Posts: 2,708
    edited December 1969

    DOH! Found it, it's in the Utilities tab :)

    aye fele tho thtoopud...

Sign In or Register to comment.
Rocket Fuel