Loading...
> >

regarding DAZ Studio 4 Frequently Asked Questions

tylerzamboritylerzambori Posts: 79
edited December 1969 in Daz Studio Discussion

Some of those links are broken. better fix them!

Comments

  • frank0314frank0314 Posts: 13,361
    edited May 2012

    Which ones are you talking about.

    Post edited by frank0314 on
  • frank0314frank0314 Posts: 13,361
    edited December 1969

    OK after looking it looks like a lot are broken. We'll se if we can get someone on those.

  • Richard HaseltineRichard Haseltine Posts: 96,737
    edited December 1969

    Aaargh -that's what comes of trying to be prepared. OK, I'll fix 'em.

  • Richard HaseltineRichard Haseltine Posts: 96,737
    edited December 1969

    OK, I think that's fixed the links, I hope - I need to remember that I've got an extra links post below the first next time I need to add an entry. I've linked to this thread as the place to make comments and suggestions.

  • ArtiniArtini Posts: 8,787
    edited December 1969

    Thanks a lot for the DAZ Studio 4 Frequently Asked Questions. It is really helpful.
    However in the post of Richard Haseltine, Posted: 08 February 2012 03:25 PM
    http://www.daz3d.com/forums/discussion/17/P15/#53
    the address to Adamr001 thread should be:
    http://forumarchive.daz3d.com/viewtopic.php?t=170864

    ----------------------------------------------------------------------------------
    Some older poses deform the Genesis™ figure
    by DAZ_Rand
    You can fix deformation of legacy poses by clicking on the deformed bodypart and then the
    little man icon at the top left of the universal manipulator then select “Restore Selected
    Item(s) Pose”

    Works like a charm

    Adamr001 has prepared a pose preset that will reset the hand and foot translations without
    changing the other settings on the hands and feet
    http://forum.daz3d.com/viewtopic.php?t=170864
    -----------------------------------------------------------------------

  • Richard HaseltineRichard Haseltine Posts: 96,737
    edited December 1969

    Thanks, I've corrected the link and added a note that Genesis has now been updated so that the issue should be a thing of the past.

  • 3dcheapskate3dcheapskate Posts: 2,689

    The links in the OP of the "DAZ Studio 4 Frequently Asked Questions" thread haven't worked for a long time (reference this post and the two posts following it). Just checked again and most of them get a "Page Not Found" error.

    Please either fix them or delete them.  :)

  • Richard HaseltineRichard Haseltine Posts: 96,737

    They must have been broken in the switch to this system, in-thread links did break. I will fix them at some point - but not today.

Sign In or Register to comment.